1988-1997 SUZUKI DT8 DT9.9 DT15 2-STROKE OUTBOARD MANUAL This outboard repair manual With its superb step by step photographs and detailed diagrams is to enable every owner to understand the workings of an outboard motor (2 or 4 stroke) and be able to fix it with relative ease. Suzuki 2-Stroke Outboard Service Manuals for only $4.95! Suzuki 2-Stroke Outboard service manuals are available for immediate download! This service is available for only $4.95 per download! If you have a dirty old paper copy of this manual or a PDF copy of this manual on your computer and it crashed we can help!
Suzuki Outboard DT50 DT60 DT65 DT55 DT65 DT75 DT85 Service Repair Workshop Manual DOWNLOAD 1. Suzuki Outboard DT50 DT60 DT65 DT55 DT65 DT75DT85 Service Repair Workshop Manual DOWNLOADINSTANT DOWNLOADOriginal Factory Suzuki Outboard DT50 DT60 DT65 DT55 DT65 DT75 DT85 Service RepairManual is a Complete Informational Book. Download SUZUKI DT OUTBOARD WORKSHOP REPAIR MANUAL. Service Manual Application: Suzuki Workshop Service Manual DT 2 THRU 225 HP 1988, 1989, 1990, 1991, 1992, 1993.
RELATED SUZUKI OUTBOARD SEARCHES:
PROPELLERS
An outboard motor is designed to develop its rated power within a specified engine speed range. The maximum rated power delivered by the Suzuki models are shown in your service manual. If the standard propeller fails to meet the above requirement, use another pitch propeller to hold the engine speed within the range specified in your manual propeller selection chart.
Installing a propeller with pitch either too high or too low will cause incorrect maximum engine speed, which may result in severe damage to the motor.
Disassembly of propeller shaft components
1. Slide propeller shaft away from reverse gear housing assembly
Account for reverse gear back-up shim thrust washer
2. Remove horizontal slider and forward gear thrust washer
3. Remove spring
4. Using special tool, push dog pin shifter.
5. Remove clutch dog shifter propeller shaft.
PROPELLER
• Inspect propeller for bent, chipped or broken blades and replace or repair if necessary.
• Inspect propeller bushing splines for wear or other damage and replace if necessary.
• Inspect propeller bushing for deterioration or slipping and replace if necessary.
PROPELLER SHAFT COMPONENTS
• Inspect horizontal slider and connector pin for excessive wear or other damage. Replace if necessary.
• Inspect clutch dog shifter for excessive wear, chip or other damage. Replace if necessary.
• Inspect dog pin for bent or other damage. Replace if necessary.
• Inspect propeller shaft / splines for wear, twist or other damage. Replace if necessary.
PROPELLER SHAFT BEARING HOUSING
• Inspect housing for cracks or other damage. Replace if necessary.
• Inspect propeller shaft bearings and reverse gear bearing for pitting, rough or other damage. Replace if necessary.
• Inspect oil seals and O-ring for cuts, nicks or tears.
Replacing propeller shaft oil seal
1. Remove retaining ring
2. Extract oil seals
1 and washer 2.3 using oil seal remover.
Do not re-use oil seal once removed.
Always use a new oil seal.
3. Apply Water Resistant Grease to inner circumference of housing.
4. Using an oil seal installer, drive two oil seals (one at a time) into housing.
The lipped portion of seal should face towards propeller.
Apply Water Resistant Grease to seal lips.
Suzuki Dt 30 Owners Manual Download
5. Install washer and retaining ring.
PROPELLER INSTALLATION
1. Install spacer shaft, then slide on propeller
2. Fit spacer specified torque.
1 and propeller stopper 2 onto propeller3.4, washer 5 and nut 6, then tighten nut to
Propeller nut : 55 N.m (5.5 kg-m, 40.0 lb.-ft.)
3. Push cotter pin secure.
PROPELLER SELECTION FOR COUNTER
ROTATION
For counter-rotation model, newly designed stainless steel propellers are available as follows.
Suzuki highly recommend to use the genuine Suzuki counterrotation propeller for the counter rotation model. In case of twin installation, always use on both engines, the same size normal rotation and counter-rotation propellers.
ENGINE CRANKED, BUT NOT START (OR STOPS SHORTLY AFTER STARTING)
UNSTABLE IDLING / TROLLING (OR ENGINE TENDS TO STALL)
• Incorrect by-pass air screw adjustment [NOTE3]
• IAC valve failure [NOTE3]
• IAC passage failure (clogged hose, etc.) [NOTE3]
• Spark plug failure
• Ignition coil failure
• ECM failure
• Wire continuity / connection failure
• Failure of high pressure fuel system components :
• Fuel injector (clog, stuck valve, etc.)
• Fuel pressure regulator (incorrect regulated pressure, etc.)
• Fuel pump (clogged suction filter, leakage in tank, etc.)
• Fuel filter (clog, etc.)
• Hose (clog, kink, leakage, etc.)
Suzuki Dt 30 Owner's Manual
REMINDER - COVID-19
Any content, information, or advice found on social media platforms and the wider Internet, including forums such as YBW, should NOT be acted upon unless checked against a reliable, authoritative source, and re-checked, particularly where personal health and liberty is at stake. Seek professional advice/confirmation before acting on such at all times.
Suzuki Dt 30 Owners Manual Free
Users who are found to promulgate FAKE NEWS on the forum in regard to this issue, intentional or otherwise, may find their access terminated. It is your responsibility to provide references to bona fide sources.
FAKE NEWS, in this regard, is that which is posited by organisations, media, etc., that is repeated on the forum, or used to support personal opinion/hypothesis posted by users - FAKE NEWS is not necessarily the personal opinion/hypothesis being posted in itself, any issues with such should be challenged respectfully.
Suzuki Dt 30 C Service Manual
IN ADDITION it seems that conspiracy theories are finding their way onto the forum. This is not the place for such content. Users who post it may find their access limited or permanently suspended. Please leave it where you find it.